OKI Data Infotech Corporation CONFIDENTIAL
Chapter 3 Maintenance Mode Functions and Operations
3-64
(When you have pressed the OK button)
(When the adjustment finishes normally)
The buzzer sounds once and the following message is displayed.
CC: Ink color
X.XX: Adjustment value A
Y.YY: Adjustment value B
Note
After the adjustment is complete, write the
adjustment values A and B on the label for
remaining sensor replacement (small), and
paste it to the position of the corresponding
color on the label (large) where all the
remaining ink sensor adjustment values are
indicated.
After you have written the adjustment values, press the OK button.
>>>POST-REPLAC ADJ
↕ CC A: X.XX B: Y.YY ◎
ADJUST COMPLETE
↕ CC A: X.XX B: Y.YY ◎
To Next Page
Loading...
