Fax Unit Options
D0CK 10 SM
2. Insert the SD card (Fax Connection Unit Type M41) in SD slot 1 (upper) with its label face towards
the front of the machine if SD slot 1 is vacant. If slot 1 is not vacant, follow “Moving a Fax
Communication application into an SD card in SD slot 1” described below.
3. Plug in, and then turn ON the main power.
4. Press [Firmware Version] in the [Machine/Control Panel Information].
"Settings" icon > [System Settings] > [Machine/Control Panel Information]
5. Check whether the aics version is displayed.
Moving a Fax Communication application into an SD card in SD slot 1
1. Insert the SD card (Fax Connection Unit Type M41) SD slot 2 (lower) with its label face towards the
front of the machine. Then push it slowly into SD slot 2 (lower) until you hear a click.
2. Plug in, and then turn ON the main power.
3. Move the Fax Connection Unit application from the SD card in SD slot 2 (lower) to the SD card in
SD slot 1 (upper) with SP5-873-001.
4. Turn OFF the main power.
5. Remove the SD card from SD slot 2 (lower), and then keep it in a safe place (see “SD Card Appli
Move” in the field service manual for the mainframe).
6. Attach the SD card slot cover, and then turn on the machine ( x 1).
7. Turn ON the main power.
8. Press [Firmware Version] in the [Machine/Control Panel Information].
"Settings" icon > [System Settings] > [Machine/Control Panel Information]
9. Check whether the aics version is displayed.
To Next Page
Loading...
