System Maintenance
SM 8-51 D0CA/D0C9/D0C8/D0CB
8.3.8 SOFTWARE UPDATE
Updating the Smart Operation Panel
• In the case of models provided with package firmware only, updates for the Smart
Operation Panel and applications are also provided via package firmware. For details,
see "Firmware Update (Removable Media)".
There are three methods to update the Smart Operation Panel. The method is different
depending on what you want to update.
1. Installation/update from a media
2. Installation/update from the eDC Server
3. Installation/update from Application Site
Update method Features Control
panel
firmware
Applications
Installation/update
from a media
Installation or update is possible in the
following two ways.
1. Applications
• Use the installation screen in the
control panel’s service mode to
update applications.
• You can install or update multiple
applications at once.
• You can also uninstall an application.
2. Package firmware (SD card or USB flash
drive)
Refer to ”Firmware Update (Removable
Media)”.
Yes Yes
Installation/update
from the eDC Server
Install or update applications directly from the
eDC Server.
This method is mainly for paid applications. A
product key is required when an application is
installed for the first time.
*The update procedure is the same as when
updating the Smart Operation Panel application
already released.
No Yes
Installation/update
from Application Site
Installation and Updating of applications and
firmware update can be done from Application
Yes*
1
Yes
To Next Page
Loading...
