Waste Toner
D0CA/D0C9/D0C8/D0CB 4-120 SM
4.11 WASTE TONER
4.11.1 WASTE TONER BOTTLE
When you replace the waste toner bottle AFTER a waste toner full or
near-full message appears on the operation panel, the PM counters are
automatically cleared after turning the main power ON.
When you replace the waste toner bottle BEFORE a waste toner full or near-full message
appears on the operation panel, do the following procedure to reset the PM counter.
1. Turn the power ON.
2. Reset the PM counter. (Refer to Replacement Procedure of the PM/Yield Parts)
3. Turn the power OF F.
Pull out the paper tray.(This procedure is for IM C300 series/IM C400F)
1. Open the front cover.
2. Pull out the waste toner bottle [A].
To Next Page
Loading...
