Ricoh IM C400F

Printer Service Mode
D0CA/D0C9/D0C8/D0CB 3-420 SM Appendices
3.11 PRINTER SERVICE MODE
1001 Bit Switch
001
Bit Switch 1 0 1
bit
0
DFU - -
bit
1
sysName Value Model name (PnP name) Hostname
This BitSw can switch the value of the sysName of the standard MIB.
0 (default):Model name (PnP name)
1: Host name
bit
2
DFU - -
bit
3
I/O Timeout Disabled Enabled
Enables/Disables MFP I/O Timeouts. If disabled, the MFP I/O Timeout setting will not
be in effect. I/O Timeouts will never occur.
bit
4
SD Card Save Mode Disabled Enabled
This BitSw enables the SD card save mode setting menu to be displayed.
After enabling this BitSw, the Card Save settings will appear under:
"User Tools > Machine Features >Printer Features > List/Test print"
bit
5
Paper Size Error Margin ±5pt ±10pt
When a PS job is printed on a custom paper size, the job might not print because of
a paper size mismatch caused by a calculation error. This BitSw can set the
allowable margin of error value.Note:This is available for PS, PDF only
bit
6
Color Balance Switching 1 Disabled Enabled
This BitSw can be used to restore the color balance to match that of Fuji-Xerox
devices. Note: If both BitSw #2-0, BitSw #2-4 and BitSw #1-6 are configured to "1",
the configuration of #2-0 will be given priority and the color balance of 09S and earlier
models will be used.
bit
7
DFU - -
1001 Bit Switch
002
Bit Switch 2 0 1
bit
0
Color Balance
Switching 2
Standard Color
Balance
Color balance of 09S and earlier
models.
This BitSw can be used to restore the color balance to match 09S and earlier model
deveices. Note: If both BitSw #2-0 and BitSw #2-4 are configured to "1", the
configuration of #2-0 will be given priority and the color balance of 09S and earlier