SC2xx: Exposure
D0CA/D0C9/D0C8/D0CB 6-22 SM
Follow the next step if executing SP2-111-004 (Forced Line Position: Adj.
Mode d) and SP2-194-007 (MUSIC Execution Result: Execution Result)
fails.
1. Clean the ID Sensors (S27-S29).
2. Check the harness and connector for ID Sensors (S27-S29).
3. Replace the ID Sensors (S27-S29).
4. Replace the BiCU (PCB1).
Check if there is no problem concerning the mechanism (interference or
deformation).
1. Execute SP5-804-021 (OUTPUT Check: TM sensor Shutter Solenoid) to operate the ID
Sensor Shutter Solenoid (SOL2) to check opening/closing of the shutter.
2. Check for a broken harness or connector disconnection.
3. If the problem cannot be solved, replace the BiCU (PCB1).
To Next Page
Loading...
