System Maintenance
D0CA/D0C9/D0C8/D0CB 8-50 SM
• The amount of time for the backup is as follows:
Example:
Data Backup time
Additional applications 106MB 1m 6s
Application settings 0.2MB 36s
Total 106.2MB 1m 42s
The default setting is “Enabled”. To change it to “Disabled”, uncheck
“Enabled”. Restarting the machine is not necessary.
In Cheetah SP mode, select [Screen Device Settings] > [Backup/Restore Settings] In Cheetah
SP mode.
Restore
• After replacing the smart operation panel, if the version of the cheetah system
firmware is older than a certain version, update it to a later version.
• If the machine doesn’t have any backup data, the restore function cannot be used.
1. Execute [Cheetah SP mode] > [Screen Device Settings] > [Backup/Restore Settings] >
[Start Restore].
2. After a message indicating that restoration takes several minutes is displayed, touch
"execute".
A message saying please wait for a while is displayed. Time is about 10 minutes.
3. After a message indicating that the next message is displayed, touch [Close].
A message that the restoration was successful is displayed.
4. Turn the main switch OFF/ON.
If restore fails, an error code appears on the operation panel.
Code Cause Solution
1 Failed to restore additionally installed application data Retry the Restore procedure.
3 Failed to restore application setting data Retry the Restore procedure.
To Next Page
Loading...
