NVRAM Data Upload/Download
SM 5-45 D0CA/D0C9/D0C8/D0CB
Maintenance
8. In order to prevent an error during the download, be sure to mark the SD card that holds
the uploaded data with the number of the machine from which the data was uploaded.
• You can upload NVRAM data from more than one machine to the same SD card.
5.9.2 DOWNLOADING AN SD CARD TO NVRAM
Do the following procedure to download SP data from an SD card to the NVRAM in the
machine.
• The NVRAM data download may fail if the SD card with the NVRAM data is damaged, or if
the connection between the controller and BiCU (PCB1) is defective.
• Do the download procedure again if the download fails.
• Do the following procedure if the second attempt fails:
• Enter the NVRAM data manually using the SMC print you created before uploading the
NVRAM data.
1. Turn OFF the power.
2. Remove the SD slot cover.
3. Insert the SD card with the NVRAM data into SD card slot 2 (lower).
4. Turn ON the power.
5. Do SP5-825-001 (NVRAM Data Download) and press [Execute].
• The serial number of the file on the SD card must match the serial number of the
machine for the NVRAM data to download successfully. The download fails if the
serial numbers do not match.
This procedure does not download the following data to the NVRAM:
• Total Count
• C/O, P/O Count
To Next Page
Loading...
