Capturing the Device Logs
SM 5-53 D0CA/D0C9/D0C8/D0CB
Maintenance
Type Storage Timing Destination (maximum
storage capacity)
• When the machine doors are opened during
normal operation
FCU device log
• When a specified amount of FCU device log
is stored in the FCU (PCB2). If fax
application is unavailable (e.g. not installed),
the machine does not transfer the log.
HDD or SD card
connected to the service
slot
Operation panel
log
• When an error related to the operation panel
occurs.
Memory in the operation
panel.
SC819 log
• When the main power button is switched On
after SC819 occurs.
HDD
• Device logs are not saved in the following conditions:
• While erasing all memory
• While data encryption equipment is installed
• While changing the firmware configuration
• Forced power OFF (accidentally disconnecting the outlet)
• Engine device log while the machine is shutting down
• When the power supply to the HDD is off because of energy saving (engine OFF
mode/STR mode)
• When one of the following SCs occurs: SC672, SC816, SC819, SC878, SC899,
SC859, SC860, SC861, SC863, or SC864
• The following logs are not saved:
• Logs related to the energy saver mode (Engine-off, suspend-mode, or other cases)
Network communication log
Logs related to NRS
IP-FAX log
Access log for unauthorized users (guests)
• HTTP session timeout log
• Auto log-out log
• IC card related log
• Authorization for Fax
Security of the Operation Log
The following operation logs related to security are not saved.
• User ID
• Password
To Next Page
Loading...
