PM/Yield Parts Settings
D0CA/D0C9/D0C8/D0CB 3-4 SM
Item SP
Separation
roller:SP3-701-160
Paper feed tray (Tray 2) Feed roller: SP3-701-150
Friction pad: SP3-701-151
Paper feed tray (Tray 3) Feed roller: SP3-701-153
Friction pad: SP3-701-154
Paper feed tray (Tray 4) Feed roller: SP3-701-156
Friction pad: SP3-701-157
Bypass feed roller SP3-701-169
The PCDU and fusing unit detect a new unit automatically.
5. Turn OFF the main power, and unplug the power cord.
6. Replace the PM parts and turn ON the power.
The machine will reset the PM counters automatically. In the case of the development unit,
developer initialization will also be done automatically.
7. Exit the SP mode.
Method 2: By [PM Counter / New Unit Set] Menu
1. Enter the SP mode.
2. Output the SMC log data using one of the following ways:
a) Execute SP5-990-001 to print SMC log data.
b) Execute SP5-992-001 to save SMC log data to an SD card. (Refer to "SMC List Card
Save Function")
Print out the PM counter list by following the procedure below.
1. In the SP mode menu, press [PM Counter / New Unit Set].
2. Press [Counterlist print out].
To Next Page
Loading...
