SD Card Options
SM 2-169 D0CA/D0C9/D0C8/D0CB
Setting items (Mac OS X):
If the driver is installed through the Bonjour function or “HP Jetdirect - Socket”, the settings will
be automatically configured.
Automatic configuration will not work if any other protocol is used for installation. In this case,
manual configuration is required.
If configuring manually, select “Adobe PostScript” if Adobe PS is used, and “Emulated
PostScript” if Clone PS is used.
Switching back to Clone PS from Adobe PS
Clone PS can be resumed by removing the Adobe PS card from the SD card slot and applying
the firmware for Clone PS/PDF (“.fwu” or “.rfu”).
• This should be done by service technicians.
In doing this, be sure to apply both PS3 and PDF firmware modules. If only one of them is
applied, the machine will not operate properly. (As a stopgap measure to fix the malfunction,
insert the optional Adobe PS card again into the SD card slot to enable the use of Adobe PS.
Then, Clone PS can be resumed by applying both the PS3 and PDF firmware modules once
again.)
Classification Firmware name Software part number
Clone PS
component firmware
Clone PS3 D0AF5573
Clone PDF D0AF5575
IRIPS Font D0AF5577
Adobe PS
component firmware
Adobe PS3 D3BD5731
Adobe PDF D3BD5733
PS3 Font D2415681
To Next Page
Loading...
