PM/Yield Parts Settings
D0CA/D0C9/D0C8/D0CB 3-8 SM
3.2.3 PREPARATION BEFORE OPERATION CHECK
Execute Automatic Color Calibration (ACC) and Forced Line Position Adjustment before
operation check.
1. Execute Automatic Color Calibration (ACC) by referring to "Automatic Color Calibration
(ACC)" section.
2. Exit the User Tools mode, and then enter the SP mode.
3. Do the "Forced line position adjustment" as follows.
• First do SP2-111-003 (Mode c).
• Then do SP2-111-001 (Mode a).
• To check if SP 2-111-001 was successful, watch the screen during the process. A
message is displayed at the end. Also, you can check the result with SP 2-194-010 to
-012.
4. Exit the SP mode.
3.2.4 OPERATION CHECK
Check if the sample image has been copied correctly.
To Next Page
Loading...
