Firmware Update (Removable Media)
D0CA/D0C9/D0C8/D0CB 5-6 SM
Using the USB Flash Drive
Use the USB slot [A] on the left side of the operation panel.
5.3.3 UPDATE PROCEDURE
Preparation
Download the latest version firmware to the removable media in advance.
Create a folder called “package” on the removable media, and then download the package
firmware (xxxxxxxx.pkg) to it.
• Do not put multiple machine firmware programs on the same SD card. Copy the only
model firmware you want.
• If you download the firmware package to the “romdata” folder, which is the one
normally used, the firmware package cannot be updated.
• When updating the firmware package of the same model, be sure to download each
version separately. If you download multiple versions for the same model, only one of
these versions is displayed on the machine’s operation panel, but which version is
displayed is unpredictable.
Note for Update
• When the power supply is switched OFF during firmware update, the update is
interrupted. When the power is switched ON again, normal operation cannot be
guaranteed.
• An update error continues to be displayed until the update is successful. In this case,
switch the power OFF, insert the removable media again, switch the power ON, and
continue the download of the firmware from the removable media.
• The PS3 firmware program is included in the preinstalled PDF firmware. In the default
state, although the PS3 firmware program is hidden in the disabled state, the function
is enabled by installing the PS3 card. (The program installed in the PS3 card is a
dongle (key) for enabling the PS3 function).
To Next Page
Loading...
