Fusing
D0CA/D0C9/D0C8/D0CB 7-78 SM
7.11.5 FUSING MODE CONTROL
When the main power switch (SW1) is turned ON, the machine starts the fusing warm-up.
The machine drives the fusing motor (M13) to increase the fusing temperature to the
reload target temperature. When the machine completes the fusing warm-up, it keeps the
reload target temperature by driving the fusing motor (M13) for a certain period of time.
When a certain period of time passes after fusing reload is completed, the machine
stops the fusing lamp and fusing motor (M13). Then the machine keeps the fusing
temperature to the standby target temperature by energizing the fusing lamp.
In standby mode, the machine starts the fusing motor (M13) intermittently.
After returning to standby mode, the machine lights the fusing lamp to increase the
fusing temperature to the printing ready target temperature. If there is no printing job,
the machine then moves back to the standby mode.
If there is a printing job, the machine starts the fusing lamp to increase the fusing temperature to
the target temperature after reload/feeding, and then starts the print job.
To Next Page
Loading...
