SD Card Options
SM 2-157 D0CA/D0C9/D0C8/D0CB
3. Store the SMC sheet on the red dotted area [A] as shown below .
4. Reattach the platen sheet.
The original application SD card should be kept in a safe place, for the following reasons:
• The SD card is the only proof that the user is licensed to use the application.
• The data on the SD card might need to be checked in the future to resolve
problems.
Move Exec
"Move Exec" (SP5-873-001) lets you move application programs from the original SD card to
another SD card.
• Do not turn ON the write protect switch of the system SD card or application SD card
on the machine. If the write protect switch is ON, a download error (e.g. Error Code 44)
occurs during a firmware update or application merge.
1. Turn OFF the power.
2. Remove the SD card slot cover [A].
3. Make sure that a target SD card is in SD card slot 1 (upper). The application program is
moved to this SD card.
4. Insert the source SD card with the application program in SD card slot 2 (lower). The
application program is copied from this source SD card.
5. Turn ON the power.
6. Enter the SP mode.
7. Select SP5-873-001 "Move Exec".
To Next Page
Loading...
