SD Card Options
SM 2-165 D0CA/D0C9/D0C8/D0CB
• SP5-832-001 (HDD Formatting (ALL))
• SP5-832-002 (HDD Formatting (IMH))
6. Set SP5-836-001 (Capture Function (0:Off 1:On)) to a value of 0 (disabled).
7. Exit the SP mode.
8. Print out the System Settings List and make sure that the option was installed
successfully.(see "Check All Connections" at the end of this section)
9. Turn OFF the main power.
10. Reattach the SD card slot cover.
11. Reattach the network cable.
12. Turn ON the main power.
Confirming the firmware version
When you finish executing SP5-878-001 ([Option Setup: Data Overwrite Security), make sure
to confirm the firmware version before executing "Auto Erase Memory"
1. Enter the SP mode, and then execute SP5-990-005 (SP print mode Diagnostic Report).
Make sure to shut down and reboot the machine once before printing the SMC. Otherwise,
the latest settings may not be collected when the SMC is printed.
2. Make sure that ROM number "D3BC5757A" and firmware version "1.02" or newer appear
in both of the following areas on the report (they must match):
• "ROM Number / Firmware Version" - "HDD Format Option"
• "Loading Program"
Configuring "Auto Erase Memory" (Performed by the Customer)
Refer to "Using "Auto Erase Memory".
2.21.4 CAMERA DIRECT PRINT CARD TYPE M37 (D3GF-30)
Component Check
No. Description Q’ty
1 SD Card 1
To Next Page
Loading...
