Controller Options
SM 2-153 D0CA/D0C9/D0C8/D0CB
After Installing the HDD
1. Connect the power cord and turn the machine on. A message prompts you to format the
hard disk.
2. Touch [Format].
3. Wait for the machine to finish formatting the hard disk.
• Do not touch the power switch while the hard disk format is in progress. Wait for
the machine to tell you that the formatting is finished.
4. Turn the machine off/on after the message tells you formatting is finished.
5. Do this step only if you are installing the option on a machine that is already in use (not a
new machine):
Enter the SP mode
Run SP5-853-001, to install the fixed stamps.
Run SP5-846-052, to copy the address book from the SD card to the HDD.
Turn off the machine, and then turn it back on.
To Next Page
Loading...
