Anti-condensation Heater
SM 2-111 D0CA/D0C9/D0C8/D0CB
18. When installing the dehumidification heater (PFU): Pull out the connector [A] and its
harness to the lower part of the machine. Then uncap the connector isolation cap in the
optional paper feed unit and connect the connector [A] to the uncapped connector.
(Dehumidification Heater (PFU))
19. Reassemble the machine.
• The mainframe and the optional paper feed unit should be joined to each other if
the dehumidification heater (PFU) is installed. See Dehumidification Heater
(PFU) for details.
To Next Page
Loading...
