Dedicated Transmission Parameters
D0CK 116 SM
0: V.34 communication will not be possible.
If the setting is "Disabled", the bit switch setting is used.
5 Compression modes
available in transmit
mode
0: MH only
1: Disabled
This bit determines the capabilities that are informed to the other
terminal during transmission.
If the setting is "Disabled", the bit switch setting is used.
6-
7
ECM during
transmission
Bit 7: 0, Bit 6: 0 = Off
Bit 7: 0, Bit 6: 1 = On
Bit 7: 1, Bit 6: 0 = Not
used
Bit 7: 1, Bit 6: 1 =
Disabled
For example, if ECM is switched on but is not wanted when sending to
a particular terminal, use the (0, 0) setting.
• V.8/V.34 protocol and JBIG compression are automatically
disabled if ECM is disabled.
• If the setting is "Disabled", the bit switch setting is used.
Switch 04 - Not used (do not change the settings)
Switch 05 - Not used (do not change the settings)
Switch 06 - Not used (do not change the settings)
Switch 07 - Not used (do not change the settings)
Switch 08 - Not used (do not change the settings)
Switch 09 - Not used (do not change the settings)
E-mail Parameters
The initial settings of the following e-mail parameters are all "0" (all parameters disabled).
Switch 00
No FUNCTION COMMENTS
0 MH Compression mode for e-mail
attachments
0: Off
1: On
Switches MH compression on and off for files attached
to e-mails for sending.
1 MR Compression mode for e-mail
attachments
0: Off
1: On
Switches MR compression on and off for files attached
to e-mails for sending.
2 MMR Compression mode for e-mail
attachments
0: Off
Switches MMR compression on and off for files attached
to e-mails for sending.
To Next Page
Loading...
