Fusing
SM 4-159 D0CA/D0C9/D0C8/D0CB
&
Adjustment
4. Rotate the separation plate [A], and remove it from the frame.
Do not apply excess force to the separation plate when removing it, to prevent the
separation plate from deforming.
When reattaching the separation plate, make sure that the plate is firmly attached to the
frame hole.
5. Remove the fusing lamp harnesses. ( × 2)
6. Remove the screws on the rear frame [A]. ( × 6)
When reattaching the harness, route the harness exactly the same way as before removal.
To Next Page
Loading...
