Firmware Update (Error Screens During Updating)
SM 5-35 D0CA/D0C9/D0C8/D0CB
Maintenance
Code Contents Solutions
• Replace the controller board (PCB24) if
the above solutions do not solve the
problem.
32 The removable media used after
download suspension is incorrect.
Removable media is different between
the one which was inserted before
power interruption and the one which
was inserted after the power
interruption.
• Insert the removable media containing the
same program as when the firmware
update was suspended, and then switch
the main power supply OFF and ON to try
again.
• There is a possibility that the removable
media is damaged if the update cannot be
done after the correct removable media
has been inserted. In this case, try again
with a different removable media.
• Replace the controller board (PCB24) if
the above solutions do not solve the
problem.
Replace all relevant boards if the update
is done for the BICU (PCB1) and FCU
(PCB2).
Replace the operation panel unit if the
update is done for the operation panel.
• After replacing the unit, update it using the
same removable media. If the update is
successful, this error code disappears.
33 Removable media version error.
The wrong removable media version is
downloaded.
• Install the correct ROM update data for
each version in the removable media.
34 Destination error.
A removable media for the wrong
destination is inserted.
• Install the correct ROM update data for
each destination (JPN/ EXP/ OEM) in the
removable media.
35 Model error.
A removable media for the wrong model
is inserted.
• Install the correct ROM update data for
each model in the removable media.
36 Module error.
The program to be downloaded does not
exist on the main machine.
The download destination specified by
the removable media does not match up
• Install the program to be updated in
advance.
• There is a possibility that the removable
media containing the program to be
updated has not been mounted. Check to
To Next Page
Loading...
