SC8xx: Overall System
D0CA/D0C9/D0C8/D0CB 6-82 SM
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
and there was no error reply from the HDD.
Power supply disconnection during data writing to the HDD.
1. This SC may occur when turning ON the machine for the first time
with a new HDD.
In this case, Automatic Reboot is performed by Kernel.
[0x696e] gwinit Processing End
If the SCS process is ended for some reason
If an unexpected error occurs at SCS processing end, gwinit processing
also halts (this result is judged a kernel stop error, by gwinit
specification)
“0x69742064” -> “init died”
1. When this error occurs, Automatic Reboot is performed by Kernel.
[0x766d] VM Full Error
Occurs when too much RAM is used during system processing
"vm_pageout: VM is full"
1. When this error occurs, Automatic Reboot is performed by Kernel.
Console
string
Other Error (characters on operation panel)
System detected internal mismatch error
• Software defective
• Insufficient memory
• Hardware driver defective (RAM, flash memory)
1. When this error occurs, Automatic Reboot is performed by Kernel.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC820-00
C Self-diagnostics Error: CPU
[XXXX]: Detailed error code
[0001] TLB change (store) exception error
[0002] TLB miss (load) exception error
[0003] TLB miss (store) exception error
[0004] Read address exception error
[0005] Write address exception error
[0006] Instruction bus exception error
[0007] Data bus exception error
[0008] System call exception error
[0009] Break exception error
[000A] Invalid instruction exception error
[000B] Co-processor exception error
To Next Page
Loading...
