SC8xx: Overall System
D0CA/D0C9/D0C8/D0CB 6-88 SM
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
video bridge device.
Defective I/F between the video bridge device and the controller
1. Replace the Controller Board (PCB24).
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC822-00
D Self-diagnostic Error: HDD
[xxxx]: Detailed error code
[3003] HDD Timeout
Check performed only when HDD is installed:
• HDD device busy for over 31sec.
• After a diagnostic command is set for the HDD, but the device remains
busy for over 6 sec.
• HDD defective
• HDD harness disconnected, defective
• Controller Board defective
1. Replace the HDD.
2. Replace the HDD connector.
3. Replace the Controller Board (PCB24).
[3004] Diagnostic Command Error
No response to the self-diagnostic command from the ASIC to the HDD.
HDD defective
1. Replace the HDD.
[3013] HDD Timeout (first machine)
HDD device busy for over 31 seconds.
A diagnostic command is set for the HDD, but the device remains busy for
over 6 seconds.
• Defective HDD device
• Defective HDD connector
• Defective ASIC device
1. Replace or remove the HDD device.
2. Replace the HDD connector
3. Replace the Controller Board (PCB24)
[3014] Diagnostics Command Error (First machine)
Result of the issuance of diagnostic command is error.
Defective HDD device
1. Replace the HDD device.
To Next Page
Loading...
