CALCulate:LIMit Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.676 E-11
CALCulate<1|2>:LIMit<1>:ACPower:ACHannel:RESult?
For details refer to "CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel:RESult?" on page 6.36.
CALCulate<1|2>:LIMit<1>:ACPower:ALTernate?
This command returns the ACP alternate channel limit for IEEE 802.11j if defined.
Parameter
numeric value in dB
Example
CALC:LIM:ACP:ALT?
Returns the IEEE 802.11j ACP alternate channel limit.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CALCulate<1|2>:LIMit<1>:ACPower:ALTernate:RESult?
For details refer to "CALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>:RESult?" on
page 6.40.
CALCulate<1|2>:LIMit<1>:BURSt:ALL
This command sets or returns all the limit values.
Parameter
The results are input or output as a list of values separated by ',' in the following (ASCII) format:
<average frequency error>, <max frequency error>,
<average symbol error>, <max symbol error>,
<average IQ offset>, <maximum IQ offset>,
<average EVM all bursts>, <max EVM all bursts>,
<average EVM data carriers >, <max EVM data carriers >
<average EVM pilots >, <max EVM pilots >
Note: The units for the EVM results are specified with the UNIT:EVM command.
Example
CALC:LIM:BURS:ALL?
All limit values are returned
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
