Rohde & Schwarz R&S FSL3 - Page 1434

R&S FSL CALCulate:LIMit Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.675 E-11
– CALCulate<1|2>:LIMit<1>:BURSt:SYMBolerror:MAXimum
– CALCulate<1|2>:LIMit<1>:BURSt:SYMBolerror:MAXimum:RESult?
– CALCulate<1|2>:LIMit<1>:BURSt:TFALl[:AVERage]
– CALCulate<1|2>:LIMit<1>:BURSt:TFALl[:AVERage]:RESult?
– CALCulate<1|2>:LIMit<1>:BURSt:TFALl:MAXimum
– CALCulate<1|2>:LIMit<1>:BURSt:TFALl:MAXimum:RESult?
– CALCulate<1|2>:LIMit<1>:BURSt:TRISe[:AVERage]
– CALCulate<1|2>:LIMit<1>:BURSt:TRISe[:AVERage]:RESult?
– CALCulate<1|2>:LIMit<1>:BURSt:TRISe:MAXimum
– CALCulate<1|2>:LIMit<1>:BURSt:TRISe:MAXimum:RESult?
– CALCulate<1|2>:LIMit<1>:SPECtrum:MASK:CHECk:X?
– CALCulate<1|2>:LIMit<1>:SPECtrum:MASK:CHECk:Y?
CALCulate<1|2>:LIMit<1...8>:FAIL?
For option WLAN TX Measurements, K91, the numeric suffixes <1...8> specify the limit lines as
follows:
Suffix Limit
1 to 2 These indexes are not used
3 ETSI Spectrum Mask limit line
4 Spectrum Flatness (Upper) limit
line
5 Spectrum Flatness (Lower) limit
line
6 IEEE Spectrum Mask limit line
7 PVT Rising Edge max limit
8 PVT Rising Edge mean limit
9 PVT Falling Edge max limit
10 PVT Falling Edge mean limit
For further details refer to "CALCulate<1|2>:LIMit<1...8>:FAIL?" on page 6.31.
CALCulate<1|2>:LIMit<1>:ACPower:ACHannel?
This command returns the ACP adjacent channel limit for IEEE 802.11j if defined.
This command is a query only and thus has no *RST value.
Parameter
numeric value in dB
Example
CALC:LIM:ACP:ACH?
Returns the IEEE 802.11j ACP adjacent channel limit.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN