Rohde & Schwarz R&S FSL3 - Page 1594

R&S FSL SENSe Subsystem (WiMAX, K92/K93)
1300.2519.12 6.835 E-11
– [SENSe:]SWEep:EGATe:HOLDoff[:TIME]
– [SENSe:]SWEep:EGATe:HOLDoff:SAMPle
– [SENSe:]SWEep:EGATe:LENGth[:TIME]
– [SENSe:]SWEep:EGATe:LENGth:SAMPle
– [SENSe:]SWEep:EGATe:LINK
– [SENSe:]SWEep:TIME
– [SENSe:]TRACking:LEVel
– [SENSe:]TRACking:PHASe
– [SENSe:]TRACking:PILot
– [SENSe:]TRACking:TIME
[SENSe:]BANDwidth:CHANnel
This command specifies the channel bandwidth for the signal to be measured. The channel is
selected via the CONFigure:CHANnel command.
Parameter
1.25 MHz to 28 MHz
Example
CONF:CHAN 9
Defines the frequency of channel 9 as measurement range.
BAND:CHAN 7MHZ
Sets a channel bandwidth value of 7 MHz.
Characteristics
RST value: 1.75 MHz
SCPI: conform
Mode
OFDM
[SENSe:]BURSt:COUNt
This command defines the number of bursts that will be analyzed by the measurement.
Parameter
1 to 10922
Example
BURS:COUN 16
Sets the number of bursts to 16.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro