Safran SecureSync 2400 - Page 223

Adding an Entry to the Reference Status Table
To add a new entry to the Reference Status table:
1.
Navigate to the Configure Reference Priorities screen via MANAGEMENT
> OTHER: Reference Priority.
2.
Click the PLUS icon in the top right-hand corner of the Configure Refer-
ence Priorities table.
3.
The Add Reference window will display:
4.
In the Add Reference window, enter:
Priority Level: Assign a priority to the new reference.
Time: Select the time reference.
PPS: Select the PPS reference.
Enabled: Check this box to enable the new reference.
5.
Click Apply or Submit. (Submit will close the window.)
Deleting a Reference Entry
To delete an entry from the Reference Status table:
1.
Navigate to the Configure Reference Priorities screen via MANAGEMENT
> OTHER: Reference Priority.
2.
In the Configure Reference Priorities table click the Delete button on the
right-hand side of the entry you wish to delete.
3.
In the pop-up window that opens click OK to confirm.
Reordering Reference Entries
To reorder the priority of a reference entry:
1.
Navigate to the Configure Reference Priorities screen via MANAGEMENT
> OTHER: Reference Priority.
3.3 Managing References
CHAPTER 3 • SecureSync 2400 User Manual Rev. 5.2
207