Siemens Sinamics G120 Series - p1055[0...2] BI: Enable JOG right; Enable JOG ->; p1056[0...2] BI: Enable JOG left; Enable JOG <-

Parameters
List of Parameters
1-124
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Defines source of JOG right when P0719 = 0 (Auto selection of command/setpoint source).
Dependency: When Standard Telegram selected (P0700 = 6, P0922 = Standard Telegram), parameter cannot be changed.
Description: Defines source of JOG right when P0719 = 0 (Auto selection of command/setpoint source).
Dependency: When Standard Telegram selected (P0700 = 6, P0922 = Standard Telegram), parameter cannot be changed.
Description: Defines source of JOG right when P0719 = 0 (Auto selection of command/setpoint source).
Dependency: When Standard Telegram selected (P0700 = 6, P0922 = Standard Telegram), parameter cannot be changed.
Description: Defines source of JOG left when P0719 = 0 (Auto selection of command/setpoint source).
Dependency: When Standard Telegram selected (P0700 = 6, P0922 = Standard Telegram), parameter cannot be changed.
Description: Defines source of JOG left when P0719 = 0 (Auto selection of command/setpoint source).
Dependency: When Standard Telegram selected (P0700 = 6, P0922 = Standard Telegram), parameter cannot be changed.
p1055[0...2] BI: Enable JOG right / Enable JOG ->
CU240E
CU240S
Access level: 3 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: T
Min Max Factory setting
- - 0
p1055[0...2] BI: Enable JOG right / Enable JOG ->
CU240S DP
CU240S DP-F
Access level: 3 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: T
Min Max Factory setting
- - 2090.8
p1055[0...2] BI: Enable JOG right / Enable JOG ->
CU240S PN Access level: 3 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: T
Min Max Factory setting
- - 8890.8
p1056[0...2] BI: Enable JOG left / Enable JOG <-
CU240E
CU240S
Access level: 3 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: T
Min Max Factory setting
- - 0
p1056[0...2] BI: Enable JOG left / Enable JOG <-
CU240S DP
CU240S DP-F
Access level: 3 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: T
Min Max Factory setting
- - 2090.9