Siemens Sinamics G120 Series - r0191[0...2] Configuration Control Unit; Config CU; p0199 Equipment system number; Equip. system no.; p0201[0...2] Act. power module code number; Act.Pmod. code no; r0203 Act. inverter type; Act. inverter type

List of Parameters
Parameters
1-33
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Displays the actual HW-configuration (SZL vector) of the Control Unit.
Index: [0] = SZL Vector CU and PM combined
[1] = SZL Vector CU
[2] = SZL Vector PM
Description: Equipment system number.
This parameter has no operation effect (only for factory purposes).
Description: Identifies hardware variant.
Index: [0] = Powerstack code
[1] = Functionality version - Last Digit of MLFB
[2] = Last used PS Id
Notice: Parameter P0201 = 0 indicates that no power module has been identified.
Description: Type number of actual inverter identified.
Values: 0: No PS Data/Module
1: reserved
2: reserved
3: reserved
4: reserved
5: reserved
6: reserved
7: reserved
110: SINAMICS G110
111: SINAMICS IPM25
114: SINAMICS PM240
115: SINAMICS PM250
125: SINAMICS ET200PRO
130: SINAMICS PM DCP
r0191[0...2] Configuration Control Unit / Config CU
Access level: 3 P-Group: - Data type: Unsigned32
Unit: - Data set: -
p0199 Equipment system number / Equip. system no.
Access level: 2 P-Group: - Data type: Unsigned16
Quick comm. NO Active: NO Data set: -
Can be changed: U, T
Min Max Factory setting
0 255 0
p0201[0...2] Act. power module code number / Act.Pmod. code no
Access level: 3 P-Group: Converter Data type: Unsigned16
Quick comm. NO Active: YES Data set: -
Can be changed: T
Min Max Factory setting
0 65535 0
r0203 Act. inverter type / Act. inverter type
Access level: 3 P-Group: Converter Data type: Unsigned16
Unit: - Data set: -