Siemens Sinamics G120 Series - p2004[0...2] Reference power; Reference power

List of Parameters
Parameters
1-199
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Full-scale reference power used over the serial link (corresponds to 4000H).
Example: If a BICO connection is made between two parameters, the 'unit' of the parameters (standardized (Hex) or physical
(i.e. kW / hp) values) may differ. In this case an automatic conversion to the target value is made.
Description: Full-scale reference power used over the serial link (corresponds to 4000H).
Example: If a BICO connection is made between two parameters, the 'unit' of the parameters (standardized (Hex) or physical
(i.e. kW / hp) values) may differ. In this case an automatic conversion to the target value is made.
p2004[0...2] Reference power / Reference power
CU240E
CU240S
Access level: 3 P-Group: Communications Data type: Floating Point
Quick comm. NO Active: NO Data set: DDS
Can be changed: T
Min Max Factory setting
0.01 2000.00 0.75
P2016
[0]
USS RS232
[1]
[2]
[3]
r0032
x[kW] y[Hex]
][4000 Hex
P2004
r0032
y[Hex] ⋅=
or
x[hp]
depending on P0100
p2004[0...2] Reference power / Reference power
CU240S DP
CU240S DP-F
CU240S PN
Access level: 3 P-Group: Communications Data type: Floating Point
Quick comm. NO Active: NO Data set: DDS
Can be changed: T
Min Max Factory setting
0.01 2000.00 0.75
P2051
[0]
Fieldbus
[1]
[2]
[3]
r0032
x[kW] y[Hex]
][4000 Hex
P2004
r0032
y[Hex] ⋅=
or
x[hp]
depending on P0100