Siemens Sinamics G120 Series - 1.5 Quick commissioning (P0010 = 1)

Quick commissioning (P0010 = 1)
Parameters
1-313
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
1.5 Quick commissioning (P0010 = 1)
The following parameters are necessary for quick commissioning (P0010 = 1).
.
Table 1-2 Quick commissioning (P0010 = 1)
Par.-No. Name Access level Can be
changed
P0100 Europe / North America 1 C
P0205 Inverter application 3 C
P0230 Output filter 1 C
P0233 Filter inductance 1 C
P0234 Filter capacity 1 C
P0300 Select motor type 2 C
P0304 Rated motor voltage 1 C
P0305 Rated motor current 1 C
P0307 Rated motor power 1 C
P0308 Rated motor cosPhi 1 C
P0309 Rated motor efficiency 1 C
P0310 Rated motor frequency 1 C
P0311 Rated motor speed 1 C
P0314 Motor pole pair number 3 C
P0320 Motor magnetizing current 3 CT
P0335 Motor cooling 2 CT
P0400 Select encoder type 2 CT
P0408 Encoder pulses per revolution 2 CT
P0500 Technological application 3 CT
P0625 Ambiant motor temperature 3 CUT
P0640 Motor overload factor [%] 2 CUT
P0700 Selection of command source 1 CT
P0727
Selection of 2/3-wire method
2CT
P1000 Selection of frequency setpoint 1 CT