List of Parameters
Parameters
1-127
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Disables additional setpoint
Description: Defines source of the additional setpoint (to be added to main setpoint).
Description: Defines source of scaling for additional setpoint (to be added to main setpoint).
Description: Displays sum of main and additional setpoints in [Hz].
Description: Displays selected frequency setpoint.
Following frequency setpoints are displayed:
• r1078 Total frequency setpoint
• P1058 JOG frequency right
• P1059 JOG frequency left
Dependency: P1055 (BI: Enable JOG right) or P1056 (BI: Enable JOG left) define command source of JOG right or JOG left
respectively.
Note: P1055 = 0 and P1056 = 0 ==> Total frequency setpoint is selected.
p1074[0...2] BI: Disable additional setpoint / Disab.add.setp
Access level: 3 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: U, T
Min Max Factory setting
- - 0
p1075[0...2] CI: Additional setpoint / Add. setpoint
Access level: 3 P-Group: Setpoints Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: T
Min Max Factory setting
- - 0
p1076[0...2] CI: Additional setpoint scaling / Add. setp.scal
Access level: 3 P-Group: Setpoints Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: T
Min Max Factory setting
- - 1
r1078 CO: Total frequency setpoint / Tot. freq.setp
Access level: 3 P-Group: Setpoints Data type: Floating Point
Unit: [Hz] Data set: -
r1079 CO: Selected frequency setpoint / Sel. freq.setp
Access level: 3 P-Group: Setpoints Data type: Floating Point
Unit: [Hz] Data set: -
To Next Page
Loading...
