Siemens Sinamics G120 Series - Fig. 2-8 2400 - Basic Operator Panel (BOP)

Function diagrams
External Interfaces
2-328
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Fig. 2-8 2400 – Basic Operator Panel (BOP)
BOP CtrlWd
r0019 r0019
BOP CtrlWd
r0019 r0019
BOP CtrlWd
r0019 r0019
BOP CtrlWd
r0019 r0019
- 2400 -
Function diagram
87654321
2400_BOP.vsd
External Interfaces
SINAMICS G120
02.04.2007 V3.0
Basic Operator Panel (BOP)
Q
Q
Basic Operator Panel BOP
5 V
0 1 0 1
0 0
5 V
5 V
Fn
5 V
P
5 V
SET (Q=1)
RESET (Q=0)
Q
Q
SET (Q=1)
RESET (Q=0)
5 V
1
5 V
0
.D
.E .B
FN
P
JOG
1 0
Raise motor potentio- meter from BOP
is selected, a changeover to the value display has taken place with the toggle key and the unit is in the "Operation" status.
Lower motor poten- tiometer from BOP Toggle key to operating system, fault acknowledgement Access parameters Actuation of seven- segment display Positive direction of rotation from BOP ON/OFF1 OFF2 from BOP
Priority 1 RESET 2 SET Priority 1 RESET 2 SET
Reset command
Set command
POWER ON
POWER ON
Note: Activation of the raise and lower keys is only effective if the operating display (r0000)
Operating display (r0000) selected and operation=1 of sequence control
Seven-segment display
Raise key
Toggle key
Reversing key
ON key
OFF key
JOG key
Program key
Lower key
r0019
.0 .1