Siemens Sinamics G120 Series - p0731[0...2] BI: Function of digital output 0; Fct. of DO0; p0732[0...2] BI: Function of digital output 1; Fct. of DO1; p0733[0...2] BI: Function of digital output 2; Fct. of DO2

List of Parameters
Parameters
1-83
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Description: Defines source of digital output 0.
Notice: An inverse logic can be realised by inverting the digital outputs in P0748.
Note: Output of fault bit 52.3 is inverted on digital output.
Monitor functions ==> see parameter r0052, r0053
Motor holding brake ==> see parameter P1215
DC-Brake ==> see parameter P1232, P1233
Description: Defines source of digital output 0.
Notice: An inverse logic can be realised by inverting the digital outputs in P0748.
Note: Output of fault bit 52.3 is inverted on digital output.
Monitor functions ==> see parameter r0052, r0053
Motor holding brake ==> see parameter P1215
Description: Defines source of digital output 1.
Description: Defines source of digital output 2.
p0731[0...2] BI: Function of digital output 0 / Fct. of DO0
PM240 Access level: 2 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: U, T
Min Max Factory setting
- - 52.3
p0731[0...2] BI: Function of digital output 0 / Fct. of DO0
PM250
PM260
Access level: 2 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: U, T
Min Max Factory setting
- - 52.3
p0732[0...2] BI: Function of digital output 1 / Fct. of DO1
Access level: 2 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: U, T
Min Max Factory setting
- - 52.7
p0733[0...2] BI: Function of digital output 2 / Fct. of DO2
Access level: 2 P-Group: Commands Data type: Unsigned32
Quick comm. NO Active: NO Data set: CDS
Can be changed: U, T
Min Max Factory setting
- - 0