Siemens Sinamics G120 Series - Page 47

List of Parameters
Parameters
1-47
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
P0341[3] Motor inertia [kg*m^2]
P0344[3] Motor weight
P0342[3] Total/motor inertia ratio
P0350[3] Stator resistance (line-to-line)
P0354[3] Rotor resistance
P0358[3] Rotor leakage inductance
P0362[3] Magnetizing curve flux 1
P0364[3] Magnetizing curve flux 3
P0366[3] Magnetizing curve imag 1
P0368[3] Magnetizing curve imag 3
P0352[3] Cable resistance
P0356[3] Stator leakage inductance
P0360[3] Main inductance
P0363[3] Magnetizing curve flux 2
P0365[3] Magnetizing curve flux 4
P0367[3] Magnetizing curve imag 2
P0369[3] Magnetizing curve imag 4
P0625[3] Ambient motor temperature
P0346[3] Magnetization time
P0347[3] Demagnetization time
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
P0340 = 1
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
P0340 = 2
x
x
P0340 = 3 P0340 = 4
P1521[3] CO: Lower torque limit
P1531[3] Regenerative power limitation
P2002[3] Reference current
P2174[3] Torque threshold M_thresh
P1520[3] CO: Upper torque limit
P1530[3] Motoring power limitation
P2003[3] Reference torque
P2185[3] Upper torque threshold 1
P2187[3] Upper torque threshold 2
P1316[3] Boost end frequency
P1460[3] Gain speed controller
P1470[3] Gain speed controller (SLVC)
P1715[3] Gain current controller
P1764[3] Kp of n-adaption (SLVC)
P1462[3] Integral time speed controller
P1472[3] Integral time n-ctrl. (SLVC)
P1717[3] Integral time current controller
P1767[3] Tn of n-adaption (SLVC)
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
P2189[3] Upper torque threshold 3
x
P0492[3] Allowed speed difference
P0494[3] Delay speed loss reaction
x
x
P1253[3] Vdc-controller output limitation
x x
P1338[3] Resonance damping gain V/f
x x x
P1345[3] Imax voltage ctrl. prop. gain
x x x
P1341[3] Imax controller integral time
x x x
P1346[3] Imax voltage ctrl. integral time
x x x