TECO A510s - Page 124

4-46
Group 08: Protection Parameters
Code Parameter Name Setting Range Default Unit
Control mode
Attribute
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
SLV2
Overload
x0xxb: Standard Motor
x1xxb: Inverter Duty
Motor
0xxxb: Reserved
1xxxb: Reserved
08-06
Start-up Mode of
Overload
Protection
Operation (OL1)
0: Stop Output after
Overload Protection
0 - O O O O O O O
1: Continuous Operation
after Overload
Protection.
08-07 Reserved
08-08
Automatic Voltage
Regulation (AVR)
0: Enable
0 - O O O O O O O
1: Disable
08-09
Selection of Input
Phase Loss
Protection
0: Disable
0 - O O O O O O O
1: Enable
08-10
Selection of Output
Phase Loss
Protection
0: Disable
0 - O O O O O O O
1: Enable
08-11
~
08-12
Reserved
08-13
Selection of
Over-Torque
Detection
0: Over-Torque
Detection is Disabled.
0 - O O O O O O O
1: Start to Detect when
Reaching the Set
Frequency.
2: Start to Detect when
the Operation is
Begun.
08-14
Selection of
Over-Torque
Operation
0: Deceleration to Stop
when Over Torque is
Detected.
0 - O O O O O O O
1: Display Warning when
Over Torque is
Detected. Go on
Operation.
2: Coast to Stop when
Over Torque is
Detected
08-15
Level of
Over-Torque
Detection
0~300 150 % O O O O O O O
08-16
Time of
Over-Torque
Detection
0.0~10.0 0.1 Sec O O O O O O O