Vector VEC-VA Series User Manual

VA Motion Controller Programming Manual
128
Step 2: Double-click the module input pin (blue dot), then pop up the “Variable Properties”
box, define the variable name, data type, usage, initial value, etc. After filling out, click OK , as
shown in the figure ;
The user caNSimply fill in the parameters that are not allowed by the axis parameters. You
can add settings according to the function requirements. Refer to 11.3.3 MC_AXIS_REF ( Axis

Vector VEC-VA Series Specifications

General

Brand	Vector
Model	VEC-VA Series
Category	Controller
Language	English