Atlas Copco Power Focus 3000 User Manual

Tool
9836 3123 01 153 (428)
11.2.6 Radio and Connection
Make settings for
Radio and
Connection.
Some of the settings
are explained in
detail below. All of
the tool configuration
parameters are listed
in tool parameter
section
Configuration.
The radio section is accessible when Primary tool is other than Cable.
T270 Power save timeout: IRC turns off after this time, if tool is inactive. To reconnect, press trigger once
and Blue LED on tool lights up after approximately 10 seconds.
T271 Start condition: The start condition if using IRC connection for tool. None: Up to 20 tightenings can
be performed if IRC connection is lost (Blue LED off). Connected: IRC connection must be established
(Blue LED on) to run tool. Start request: IRC connection must be established (Blue LED on) and link
time out must not have started.
T272 Link timeout: If the tool loses IRC connection it is considered offline and the connection LED (blue)
on the tool turns off after the link timeout time.
T277 Torque and angle trace: Switch on/off tracing of torque and angle. (Up to 10 traces can be stored in
the tool if connection is lost.)
T290 Primary tool. Note that PF needs to be restarted after changing primary tool setting. Click Store to
save settings.

Atlas Copco Power Focus 3000 Specifications

General

Brand	Atlas Copco
Model	Power Focus 3000
Category	Control Systems
Language	English