Parameter list
9836 3123 01 361 (428)
22.4.2 Configuration
Defines what device is to be used when selecting the running Pset.
Available options; Off, Selector, DigIn, Ethernet/Serial, Identifier, Fieldbus,
PF Keyboard, Fieldbus selector, STwrench tag and ST Selector.
Defines what device is to be used when selecting the running Job.
The option is accessible when Job is accessible (RBU type).
Available options; Off, DigIn, Ethernet/Serial, Identifier, Fieldbus and PF
Keyboard
Defines what device is to be used when selecting the running Job.
This source has a higher priority than C201 Job. The option is accessible when
Job is accessible (RBU type).
Available options; Off, DigIn, Ethernet/Serial, Identifier, Fieldbus and PF
Keyboard
When this parameter is activated, the tool locks when a NOK tightening has
occurred.
Available options; No, DigIn unlock and Rev ring unlock
To unlock tool use digital input unlock, rev ring unlock, Fieldbus or the
Ethernet/serial protocol.
Result of non-
tightenings
Yes/No
If Yes is selected, then a non-tightening event i.e. loosening, batch operation
will generate a result.
If the checkbox is selected, then the non-tightening events; OK loosening,
batch increment or batch decrement generate a result that is stored in the PF
database. This parameter is used for Pset and Multistage. For Job, see J341.
Yes/No
Used to prevent the operator from loosening a correctly tightened joint.
Reverse/Forward/Reverse Torque Based
Selects type of positioning mode for open end.
Reset batch at Pset
change
Yes/No
Resets the batch counter when a new Pset is selected.
Reset batch at Pset
store
Yes/No
Used if batch counter for a Pset is to be stored, and a reset of batch counter is
wanted.
Decrement batch at
OK loosening
Yes/No/If last tightening OK
If YES, an OK Loosening generates a batch decrement for both OK and NOK
tightening. Set to If last tightening OK to decrement only for OK tightening.
This function only works with a single spindle, NOT with Sync.
Batch status at
increment
OK/NOK
Defines if an increment or bypass operation is OK or NOK.
To Next Page
Loading...
Need help?
General
