Parameter list
362 (428) 9836 3123 01
Increase batch at
tightening
OK tightening
OK+NOK tightening
Defines if batch counter shall be increased at OK tightenings or at OK+NOK
tightenings.
Yes/No
Use last Pset which was selected before Power Focus reboot.
Time and date are set by this command.
Opens the window for event log and display options.
22.4.3 Network
The IP address is a number for identification in a network.
Specifies the number of IP addresses on the subnet and also the number of PF
that can be placed below a Net reference, if no router is used.
IP address of the router used on the subnet.
Identification number of the channel/system to which the programming refers.
Valid values are 0-20. 0 is only used for standalone PF.
Name of PF. It is possible to use up to 25 characters.
Defines the IP address to the Power Focus acting Cell reference.
The Cell reference monitors and collects information from the Cell members
included in the group.
This IP address must be written into each included Cell member.
The Cell ID is a unique number for the Cell reference (a kind of identification
number).
Valid values are 0-1000. Accessible when the Power Focus is a Cell reference.
A unique name to be able to find the Cell in the network.
It is possible to use up to 25 characters. Accessible when the Power Focus is a
Cell reference.
Defines the IP address to the Power Focus acting Net reference.
The Net reference monitors and collects information from the Net members
included in the group.
This IP address must be written into each included Net member.
To Next Page
Loading...
Need help?
General
