Atlas Copco Power Focus 3000 - Configuration of identifier functions

Identifier
192 (428) 9836 3123 01
 The parameters J342 Reset all identifier at Job done and I183 Reset all identifiers at Pset batch done are
activated
After a reset, the following occur:
 All identifiers are reset
 Work order is (cleared) aborted
 Tool is unlocked if I181 Tool locked during work order is activated
14.3 Configuration of identifier functions
The identifier functions are related to a number of parameters
and views.
Identifier includes settings for configuration of identifiers, result
parts and work order. A command to send an identifier to PF
directly is also located here.
Configuration; Identifier can be set as the source to select Pset,
Job, or Job override.
Memory includes settings for Result parts. Note that memory
reconfiguration requires saving of PF to file and reboot of PF. If
a memory reconfiguration is needed, it is recommended to start
the procedure here. See section Memory.
Identifier Monitor displays the result parts. The following
functions are also available here:
 Bypass identifier
 Reset latest identifier
 Reset all identifiers