Parameter list
9836 3123 01 367 (428)
Type of tool, fixed or handheld. Fixed tools have a lower max speed, which
means that this parameter has to be evaluated when calculating the speed
factor.
Options available. Handheld and Fixed
Accessible when a tool is connected, except STB offline.
Shows the maximum tightening torque for the tool in chosen unit. Possible
values between 0.1 and 6553 Nm.
The value is possible to change if correct password privileges are met.
Accessible when a tool is connected, except STB offline.
This parameter must only be changed by users with tool
knowledge. Read only access for ST/SL tools and STB online.
Shows the mechanical gear ratio for the tool.
Tool production date. In Unix format.
Shows the serial number of the tool.
Shows information about the motor size in the tool.
Shows information about the connected Tensor tool type.
Accessible when an ETX tool is connected.
Shows the serial number of the tool.
Accessible when an ETX tool is connected.
Accessible when an ETX tool is connected.
Accessible when an ETX tool is connected.
Shows the serial number of the tool.
Accessible when an ETX tool is connected.
Accessible when an ETX tool is connected.
Accessible when an ETX tool is connected.
Shows the version number of the application code.
Shows the version number of the boot-code.
22.5.2 Configuration
The tool parameters are visible depending on which tool is connected. For STB, most parameters are
invisible when the tool is offline.