Atlas Copco Power Focus 3000 User Manual

Tool
158 (428) 9836 3123 01
11.4.1 Calibration and Service
Make settings for
Calibrations and Service.
Click Store to save the
settings.
11.4.2 Open-end tuning
Before using an open-end tool, make sure that the tool head and tool body have been assembled and
configured correctly. If not, the tool can run in the wrong direction and the mechanical stop in the open-
end head may be damaged.
If performing an OK tightening (green tool LED’s are on) with C230 OE forward positioning set to “No”
and pressing the tool trigger button, then the LED’s turn OFF and ON again. This behavior can only be
seen on S and DS tools (not on ST and SL tools) and is normal.
The “Reverse angle” and “Rotate spindle forward/reverse” strategies are not applicable for open-end
tools.
It is not possible to use open-end tools in a Multistage configuration.

Atlas Copco Power Focus 3000 Specifications

General

Brand	Atlas Copco
Model	Power Focus 3000
Category	Control Systems
Language	English