Parameter list
9836 3123 01 353 (428)
The lower control limit for range. Calculated automatically or entered
manually.
This function is only available if P220 PVT monitoring is selected.
The upper control limit for range. Calculated automatically or entered
manually.
This function is only available if P220 PVT monitoring is selected.
The desired value for calculated mean values for groups of tightenings.
This function is only available if P220 PVT monitoring is selected.
The desired value for calculated mean ranges for groups of tightenings.
This function is only available if P220 PVT monitoring is selected.
The lower control limit for mean value.
Calculated automatically or entered manually.
The upper control limit for mean value.
Calculated automatically or entered manually.
Defines the low limit for permitted variations in the range calculations.
Defines the high limit for permitted variations in the range calculations.
Defines the desired CM average for all of the subgroups calculated
automatically or entered manually. (If calculated: In each subgroup the
average tightened CM value is calculated. Then an average is calculated
based on all of the averages.)
Defines the desired average of the CM variation for all of the subgroups.
Calculated automatically or entered manually. (In each subgroup the average
tightened CM variation is calculated. Then an average is calculated based on
all of the averages.)
22.2 Multistage
22.2.1 Setup
View existing
Multistages
To view all existing Multistages.
To create a new Multistage.
Used for the copying of an existing Multistage.
Used when a Multistage is to be deleted.
To Next Page
Loading...
Need help?
General
