Parameter list
352 (428) 9836 3123 01
The desired value for calculated mean ranges for groups of tightenings.
The lower control limit for mean value.
Calculated automatically or entered manually.
This function is only available if parameter P104 Rundown angle is selected.
The upper control limit for mean value.
Calculated automatically or entered manually.
The lower control limit for range.
Calculated automatically or entered manually.
This function is only available if parameter P104 Rundown angle is selected.
The upper control limit for range.
Calculated automatically or entered manually.
This function is only available if parameter P104 Rundown angle is selected.
The desired mean value for calculated mean values for groups of tightenings.
This function is only available if parameter P104 Rundown angle is selected.
The desired mean value for calculated mean ranges for groups of tightenings.
This function is only available if parameter P104 Rundown angle is selected.
The lower control limit for mean value.
Calculated automatically or entered manually.
This function is only available if parameter P210 Selftap is selected.
The upper control limit for mean value.
Calculated automatically or entered manually.
This function is only available if parameter P210 Selftap is selected.
The lower control limit for range.
Calculated automatically or entered manually.
This function is only available if parameter P210 Selftap is selected.
The upper control limit for range.
Calculated automatically or entered manually.
This function is only available if parameter P210 Selftap is selected.
The desired value for calculated mean values for groups of tightenings.
This function is only available if parameter P210 Selftap is selected.
The desired value for calculated mean ranges for groups of tightenings.
This function is only available if parameter P210 Selftap is selected.
The lower control limit for mean value. Calculated automatically or entered
manually.
This function is only available if P220 PVT monitoring is selected.
The upper control limit for mean value. Calculated automatically or entered
manually.
This function is only available if P220 PVT monitoring is selected.
To Next Page
Loading...
Need help?
General
