Parameter list
356 (428) 9836 3123 01
This parameter switches the angle SPC alarm function on or off.
Not accessible when a DS strategy or reverse is selected (see P100 Control
strategy).
This parameter switches the current monitoring SPC alarm function on or off.
Accessible when P200 Current monitoring is activated.
22.3 Job
22.3.1 Setup
To view existing Jobs in the current PF channel. Both numbers and logical
names will be displayed.
Create and open a new Job.
Each Job has a unique ID number between 1 and 99 (or up 400 with the
configurable memory function). Combining selected Psets/Multistages creates a
Job.
The new Job contains default values on all parameters.
The name of the Job helps the operator to identify the different Jobs (maximum
25 characters).
Power Focus offers the possibility to copy the properties of an already existing
Job to another Job. If the target Job has not already been created it will be
created automatically. The source Job keeps its Job ID and the target Job gets a
new Job ID.
This function deletes an already existing Job from the Power Focus memory and
the RBU. A running Job will be considered as aborted before it is deleted.
To Next Page
Loading...
Need help?
General
