Available when A232 Selector external controlled is set to No. Options: off, on,
on with acknowledge.
Off: function disabled.
On: when a new Pset/Multistage is selected Power Focus needs a confirmation
signal from the selector. This is made by lifting a socket from the indicated
socket tray. The exception is when a Pset/Multistage from the same socket tray
is selected sequentially. Then no confirmation is needed.
On with acknowledge: Every time a new Pset/Multistage is selected Power
Focus needs a confirmation signal from the selector. This is made by lifting a
socket from the indicated socket tray.
With this option there is no exception when a Pset/Multistage from the same
socket tray is selected sequentially. Then the Power Focus still needs a
confirmation signal from the selector
Determines whether the last selected Pset or “No Pset” is selected when
communication with a selector is lost. Available when A232 Selector external
controlled is set to No.
Turns selectors into externally controlled mode. Used to externally control the
Selector LED’s via fieldbus items Selector control green light and Selector
control red light. For more information, see section Digital I/O and fieldbus
items.
To Next Page
Loading...
Need help?
General
