Atlas Copco Power Focus 3000 User Manual

Fieldbus
9836 3123 01 235 (428)
Network Access Port (NAP)
The NAP (Network Access Port) provides temporary access to the ControlNet network for diagnostic and
configuration. (RJ45)
ControlNet channels A & B
The module is equipped with two BNC contacts for connection to ControlNet. If redundant operation is
desired both connectors are used, otherwise connector A or B is used. (BNC)
Mac ID switches (x10 and x1)
On a ControlNet network, each node must be assigned its own unique node address. The module features
on board switches for Mac ID configuration, providing an address range of 1 – 99.
In the example below the Mac ID is set to 42 (4 x 10 + 2 x 1).
Indicators
ControlNet status indicators indicate run time status and errors to the user.
LED
Indication
State
Description
1
Module status
Green
Connection in run state
Green Flashing
Connecting connection idle
Red
Major fault
Red Flashing
Minor fault
2 and 3
Channel A and Channel B
Off
Module not initialized
Red
Major fault
Alternating red/green
Self test
Red Flashing
Node configuration error, duplicate Mac ID etc.
2 or 3
Channel A or Channel B
Off
Channel disabled
Green
Normal operation of channel
Green Flashing
Temporary error (node will self correct) or not configured
Red Flashing
No other nodes, or media fault
Red & Green Flashing
Network configuration error
4
Module owned
Off
No connection has been opened
Green
A connection has been opened towards the module

Atlas Copco Power Focus 3000 Specifications

General

Brand	Atlas Copco
Model	Power Focus 3000
Category	Control Systems
Language	English