5. Installation
2. To get history of the used lamps, click from history (3).
The Reset lamp history selection window opens (4).
3. Click on Select (5) to display a list of possible lamps (6).
4. Select the desired lamp (7) and click OK (8).
The article number and serial number of the selected lamp is added to the Reset lamp parameters
window (10). The lamp run time and number of strikes of this lamp are added in Lamp parameter
preview (12).
5. The lamp parameters can be edited by the user under personnel maintenance and responsibility. If you
want to change these parameters, check the check box in front of Edit lamp parameters (11).
The current parameter fields become active (12).
6. Click in an input field and change to the desired value.
7. Click Reset lamp (13).
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012
133
To Next Page
Loading...
