7.7.2.2 Restoring Factory Defaults
In DevConfig, clicking the Factory Defaults button at the base of the Settings
Editor tab sends a command to the CR1000 to revert to its factory default
settings. The reverted values will not take effect until the changes have been
applied.
7.7.2.3 Saving and Restoring Configurations
In DevConfig, clicking Save on a summary screen saves the configuration to an
XML file. This file can be used to load a saved configuration back into the
CR1000 by clicking Read File and Apply.
Figure 38. Summary of CR1000 Configuration
7.8 CRBasic Programming — Details
Related Topics:
• CRBasic Programming — Overview (p. 86)
• CRBasic Programming — Details (p. 122)
• CRBasic Programming — Instructions (p. 537)
• Programming Resource Library (p. 169)
• CRBasic Editor Help
Programs are created with either Short Cut (p. 528) or CRBasic Editor (p. 125). Old
CR10X and CR23X programs can be converted to CRBasic code using
Transformer.exe (executable file included with LoggerNet). Programs can be up
to 490 KB in size; most programs, however, are much smaller.
122
To Next Page
Loading...
Need help?
General
